The Frontier® 100 12 volt submersible pump by Proactive Environmental Products International LLC (PEPI)® is engineered for the homeowner in mind. The Frontier® 100 submersible centrifugal pump is capable of pumping up to 100 feet from ground level (DTW)*. The Frontier® 100 is very easy to use....Just hose clamp onto the pump barb tip a 3/8" id tubing and attach a suspension wire (preferable stainless steel) to the eye hook provided on top of the pump. Then, lower the pump to the desired water depth and energize the pump with a 12 volt deep cycle AGM battery or several other "powering" options pictured on the right side of the page.  The Frontier® 100 pump will fit into a schedule 40 or 80 2 inch well or larger. The Frontier® 100 is perfect for showers, toilets, watering shrubs. Please note: The Frontier® 100 pump is not suitable for drinking water consumption because the Frontier® 100 has yet to be NSF approved.  (Please note: All "powering" products on the right side of this page incorporates a "Pro Booster #1" except Crusader and 60 Amp Mobile Battery Pack)

 

Simplify and Expedite Your Next Event!

 

• Frontier® 100 can operate under harsh conditions with higher turbidity.

 

• Frontier® 100 can run continuously in water without the need for a cool down!

 

• Frontier® 100 has a 1,000 hour motor module life!

 

• Frontier® 100 has a sleek outside that minimizes well hang-ups.

 

• Frontier® 100 is a very reliable and economical pump that provides a great bang for your buck!  

 
Easy to fix if a problem should arise: Let's face it, mechanical parts break down after a while. The life expectancy of the motor module is around 1,000 hours or so.  Please Keep in mind... the life of the motor module depends of course how often it is used (this is for any pump or a matter of fact anything mechanical). The great benefit of the Frontier® 100 pump is the patented (#7584785) replaceable motor module that can be changed out within 60 seconds. That means no down time and NO expensive service calls. Just twist in the new motor module and start pumping again, truly peace of mind!! Once the new motor module is installed, your pump is essentially new and will have a life span identical to a new pump. Please note, the Frontier® 100 pump ships to you with one motor module installed on the pump. 

 

Important Notes and Friendly Reminders:

 

•  The Frontier® 100 pump cannot be used as pressure pump under any circumstances. The  Frontier® 100 pump is engineered to discharge water into a large holding tank of water.  Then from that large holding tank another pump needs to be used to pump to your final destination.

• Do not valve down the Frontier pump with valves or any other mechanical devices. If you need to achieve a lower water discharge rate then please purchase the "Pro Controller #1."  Pictured on the right side of this page. 

 

The Frontier® 100 pump is engineered for ease of use. The pump consist of 4 components:

 

1. The replaceable motor module

2. The motor module 4 Pin Bayonet Connector 

3. The outside PVC Housing and PVC Bottom Inlet Filter Screen 

4. The pump power wire

 

THE Frontier® 100 PUMP WIRE CANNOT BE CUT DOWN TO SHORTER LENGTHS.  DOING SO WILL OVER AMP AND OVER VOLT THE MOTOR MODULE CAUSING PREMATURE FAILURE!!

 

*Depth To Water